A3 Mk2
| Exploded view - pedal cluster, clutch master cylinder |
| 1 - | Pipe/hose assembly |
| q | With frequency modulator |
| q | Disconnecting from clutch master cylinder and slave cylinder → Fig. |
| q | Removing and installing → Chapter |
| 2 - | Seal or O-ring |
| q | Renew damaged seals or O-rings |
| q | Push onto pipe connection |
| q | Lubricate with brake fluid before installing |
| q | Whether a seal or an O-ring is used depends on the type of connection → Fig. |
| q | For correct version, refer to → Electronic parts catalogue |
| 3 - | Clip |
| 4 - | Supply hose |
| q | To brake fluid reservoir |
| q | Made of rubber or plastic, depending on version |
| q | Plastic supply hose with additional seals → Fig. |
| 5 - | Nut |
| q | 20 Nm |
| q | 3x |
| q | Self-locking |
| q | Renew |
| 6 - | Seal |
| q | Renew |
| 7 - | Mounting bracket |
| q | For clutch pedal |
| q | Removing and installing → Chapter |
| 8 - | Bolt |
| 9 - | Bearing bush |
| 10 - | Pivot pin |
| 11 - | Clutch pedal |
| q | Removing and installing → Chapter |
| 12 - | Bearing bush |
| 13 - | Nut |
| q | 25 Nm |
| q | Self-locking |
| q | Renew |
| 14 - | Retaining clip |
| q | For operating rod on clutch master cylinder |
| 15 - | Over-centre spring |
| q | Removing and installing → Chapter |
| 16 - | Seal |
| q | Renew |
| 17 - | Clutch master cylinder |
| q | Removing and installing → Chapter |
| 18 - | Clutch position sender -G476- |
| q | Removing and installing → Chapter |
| q | Can be checked in „Guided fault finding“ using → vehicle diagnostic tester |
|
|