Audi Workshop Service and Repair Manuals

Removing and installing gear selector cable and gate selector cable

Removing –  Remove selector mechanism → Chapter –  Using a screwdriver, bend open tabs -arrows- for selector mechanism on floor plate and remove floor plate. –  Remove gasket.

–  Take off securing clips -1 ... 4- and detach gear selector cable and gate selector cable from selector housing.

–  Release cable end-pieces -A- for gate selector cable and gear selector cable -B- as follows: –  Push sleeve forwards onto stop -arrow 1-. –  Turn sleeve clockwise onto stop -arrow 2- so that it engages. –  Detach cable end-pieces from cables.

–  Pull off securing clips -1- and -2-. –  Detach support bracket from cables.

Installing Installation is carried out in reverse sequence; note the following: –  Secure gear selector cable and gate selector cable to selector housing with securing clips -1 ... 4-.

–  Fit gasket and secure floor plate to selector mechanism by bending over tabs -arrows-. –  Install selector mechanism → Anchor. –  Adjust selector mechanism → Chapter.