| –
| Shift selector lever into position „P“. |
| –
| Loosen bolt -arrow- for adjustment of selector lever cable. |
| –
| Move gearbox selector lever into position „P“ on gearbox. To check this position, press gearbox selector lever towards rear of vehicle as far as stop. |
Note | To be sure that the gearbox is in „P“ (parking lock engaged), lift vehicle. It should not be possible to turn both front wheels simultaneously in the same direction. |
| –
| To release tension in selector lever cable, carefully move selector lever slightly forwards and backwards, without shifting into a different position. |
| –
| Tighten adjuster screw -arrow-, taking care not to alter position of selector lever cable. |
| Checking adjustment of selector lever cable |
| –
| Keep button pressed, while pulling selector lever approx. 5 mm to the rear out of position „P“. Then keep lever in this position, do not move it into „R“. |
| –
| Release selector lever. |
| l
| The selector lever should spring back into position „P“ by itself. |
| –
| Shift selector lever into position „N“. |
| –
| Keep button pressed, while pulling selector lever approx. 5 mm to the rear out of position „N“. Then keep lever in this position, do not move it into „D“. |
| –
| Release selector lever. |
| l
| The selector lever should spring back into position „N“ by itself. |
| –
| Keep button pressed, while pushing selector lever approx. 5 mm to the front out of position „N“. Then keep lever in this position, do not move it into „R“. |
| –
| Release selector lever. |
| l
| The selector lever should spring back into position „N“ by itself. |
| –
| Repeat the adjustment if the selector lever does not react as described. |
|
|
|
