audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox > < Removing and installing selector lever lock solenoidN110

A3 Mk2

Checking connectors on selector mechanism
Checking connectors on selector mechanism
Before servicing or checking the connectors, the cause of the fault should be identified via Guided Fault Finding using the vehicle diagnostic tester.
Before checking the connectors, all the control units in the vehicle should be checked for entries in the event memory using the vehicle diagnostic tester; repair faults as necessary.
   
–  Check connectors according to → Current flow diagrams, Electrical fault finding and Fitting locations.
1 - Electrical connector for wiring from shift unit to gearbox (with CAN bus wire) and to selector lever lock solenoid -N110- and selector lever locked in position P switch -F319-
2 - Electrical connector for trim frame with selector lever display illumination bulb -L101- and selector lever position display -Y26-
  A37-11026

Removing and installing gearbox > < Removing and installing selector lever lock solenoidN110