Audi Workshop Service and Repair Manuals

Removing and installing wiring harness with 14-pin connector

A -	14-pin connector

B -	Wiring harness leading to 14-pin connector

q	Designation of solenoid valves and routing of wiring harness → Chapter

Note! t  Rules for cleanliness when working on the automatic gearbox → Chapter. t  General repair instructions → Chapter.

Removing wiring harness with 14-pin connector   Caution Follow steps required when disconnecting battery → Electrical system; Rep. Gr.27. –  Press release tab -arrow- and remove cover -1- over battery.

–  With ignition switched off, disconnect earth wire -arrow- at battery. –  Remove oil pan → Chapter. –  Remove ATF strainer → Chapter. –  Remove valve body → Chapter

When gearbox is installed: –  Detach 14-pin connector -A- from gearbox connector.

All models: –  Remove bolt securing 14-pin connector to outside of gearbox housing. –  Pull connector out of gearbox housing and carefully guide wiring harness -D- out behind. Installing wiring harness with 14-pin connector Installation is carried out in reverse sequence; note the following: –  Renew O-ring on connector. –  Lubricate O-ring lightly with ATF. –  Press connector with O-ring fitted into gearbox as far as it will go. Tightening torque

Component	Nm
Securing bolt for 14-pin connector	5.5