audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox input speed sender G182 > < Removing and installing wiring harness with 14-pin connector

A3 Mk2

Removing and installing wiring harness with 8-pin connector and integrated gearbox oil temperature senderG93
   
Removing and installing wiring harness with 8-pin connector and integrated gearbox oil temperature sender -G93-
A - 8-pin connector
B - Wiring harness leading to 8-pin connector
q   Components on wiring harness → Chapter

  Note!
t  Rules for cleanliness when working on the automatic gearbox → Chapter.
t  General repair instructions → Chapter.
   
Removing wiring harness with 8-pin connector
  Caution
Follow steps required when disconnecting battery → Electrical system; Rep. Gr.27.
–  Press release tab -arrow- and remove cover -1- over battery.
  A27-0190
–  With ignition switched off, disconnect earth wire -arrow- at battery.
–  Remove oil pan → Chapter.
–  Remove ATF strainer → Chapter.
–  Remove valve body → Chapter
  A10-1612
When gearbox is installed:
–  Detach 8-pin connector -B- from gearbox connector.
  A37-0569
All models:
–  Remove bolt securing 8-pin connector to outside of gearbox housing.
–  Pull connector out of gearbox housing and carefully guide wiring harness -C- out behind.
Installing wiring harness with 8-pin connector
Installation is carried out in reverse sequence; note the following:
–  Renew O-ring on connector.
–  Lubricate O-ring lightly with ATF.
–  Press connector with O-ring fitted into gearbox as far as it will go.
Tightening torque
  A38-0106
ComponentNm
Securing bolt for 8-pin connector 5,5

   

Removing and installing gearbox input speed sender G182 > < Removing and installing wiring harness with 14-pin connector