audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox > < Removing and installing selector lever lock solenoid N110 (vehicles from 11.2009 onwards)

A3 Mk2

Checking connectors on shift unit (vehicles from 11.2009 onwards)
Checking connectors on shift unit (vehicles from 11.2009 onwards)
Before servicing or checking the connectors, the cause of the fault must be determined via the Guided Fault Finding → vehicle diagnostic tester.
Before checking the connectors, all the control units in the vehicle should be checked for entries in the event memory; repair faults as necessary → vehicle diagnostic tester.
   
–  Check connectors according to → Current flow diagrams, Electrical fault finding and Fitting locations.
1 - Electrical connector for wiring to selector mechanism cover
2 - Electrical connector for wiring from shift unit to gearbox (with CAN bus wires) and to selector lever lock solenoid -N110- and selector lever locked in position P switch -F319-
  A37-11026

Removing and installing gearbox > < Removing and installing selector lever lock solenoid N110 (vehicles from 11.2009 onwards)