audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing selector lever handle (vehicles with selector lever boot, up to 11.2009) > < Exploded view - selector lever handle with selector lever boot, selector lever display illumination bulb L101 (vehicles up to

A3 Mk2

Operating manual release for selector mechanism from position “P” (vehicles with selector lever boot, up to 11.2009)
Operating manual release for selector mechanism from position “P” (vehicles with selector lever boot, up to 11.2009)
t  The selector lever lock solenoid -N110- locks the selector lever in position “P”. The selector lever can then only be shifted out of position “P” when the ignition is on / the engine is running, the brake pedal is depressed and the button on the selector lever handle is pressed → Chapter.
t  In the event of malfunctions in the supply voltage to the selector lever lock solenoid (discharged battery or defective fuse) or if the solenoid is defective the selector lever cannot be shifted out of position “P”, i.e. the vehicle cannot be moved, as the parking lock is engaged.
In this case:
–  Check fuses → Current flow diagrams, Electrical fault finding and Fitting locations.
–  Check battery voltage → Electrical system; General information; Rep. Gr.27.
If fault finding has not been successful and selector lever can still not be shifted from “P” the solenoid must be released manually. However, if the selector lever is then moved back to “P” it will remain locked in position “P” once again.
   
Procedure
–  Unclip retaining frame for selector lever boot -1- from centre console and lift off -arrows-.
–  Turn up selector lever boot.
  A96-10094
–  Use the screwdriver -1- from the vehicle tool kit to release the selector lever lock solenoid -A-.
–  To do so press lever -B- inwards -arrow- with the screwdriver and keep it in this position. The solenoid will then release the selector lever.
  Caution
If parts of the shift unit are damaged, the shift unit has to be renewed as a complete unit.
  Note
The selector mechanism is shown without selector lever handle for ease of illustration. However, it is not necessary to remove the selector lever handle to operate the manual release mechanism.
–  Now press button on selector lever knob (with solenoid released) and shift selector lever out of “P”.
  Note
However, if the selector lever is now moved back to “P” the selector lever lock solenoid will once again mechanically lock it in position “P”. The solenoid must be released once again.
  A34-0677

Removing and installing selector lever handle (vehicles with selector lever boot, up to 11.2009) > < Exploded view - selector lever handle with selector lever boot, selector lever display illumination bulb L101 (vehicles up to