audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pipes (front) > < Removing and installing coolant pipes (left-side)

A3 Mk2

Removing and installing coolant pipe (right-side)
Removing and installing coolant pipe (right-side)
Special tools and workshop equipment required
   
t  Hose clamps for hoses up to 25 mm -3094-
  W00-0079
t  Drip tray for workshop hoist -VAS 6208-
  W00-10228
t  Hose clip pliers -VAS 6362-
  W00-10427
Removing
–  Remove noise insulation → Rep. Gr.50.
  A10-10761
–  Place drip tray for workshop hoist -VAS 6208- beneath engine.
–  Clamp off coolant hoses -arrows- with hose clamps -3094- and detach.
–  Remove bolts -1- and -2- and take off coolant pipe (right-side).
Installing
l  Tightening torques → Chapter
Installation is carried out in the reverse order; note the following:
–  Install noise insulation → Rep. Gr.66.
–  Check coolant level → Anchor.
  A19-10612

Removing and installing coolant pipes (front) > < Removing and installing coolant pipes (left-side)