audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing sump > < Oil pump, sump, balance shaft assembly - exploded view

A3 Mk2

Removing and installing oil level and oil temperature senderG266
Removing and installing oil level and oil temperature sender -G266-
   
Removing
–  Drain off engine oil → Booklet808.
–  Unplug electrical connector -arrow- at oil level and oil temperature sender -G266-.
  A10-11352
–  Release fasteners -arrows- and remove noise insulation -1- for sump.
  A17-10410
–  Remove bolts -1- and detach oil level and oil temperature sender -G266--item 4-.
  Note
Disregard -item 3-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Oil pump, sump, balance shaft assembly - exploded view“
  Note
Renew seal -2- and self-locking bolts -1-.
–  Fill with engine oil and check oil level → Booklet808.
  A17-0294

Removing and installing sump > < Oil pump, sump, balance shaft assembly - exploded view