audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing bracket for ancillaries > < Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioning roller

A3 Mk2

Removing and installing vibration damper
Removing and installing vibration damper
Removing
l  Front wheel housing liner removed (front section, right-side) → Rep. gr.66.
–  Remove poly V-belt:
t  → Chapter „Removing and installing poly V-belt - vehicles without air conditioner compressor“
t  → Chapter „Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioner“
t  → Chapter „Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioning roller“
   
–  Counterhold by applying ring spanner to bolt for crankshaft sprocket and slacken bolts for vibration damper.
–  Remove bolts and take off vibration damper.
  A13-0356
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Poly V-belt drive with air conditioner compressor and tensioning roller - exploded view“
  Note
Renew the bolts tightened with specified tightening angle.
l  Installation position: hole -arrow- in vibration damper must be positioned over raised section of crankshaft sprocket.
–  Install poly V-belt:
t  → Chapter „Removing and installing poly V-belt - vehicles without air conditioner compressor“
t  → Chapter „Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioner“
t  → Chapter „Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioning roller“
  A13-0134

Removing and installing bracket for ancillaries > < Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioning roller