audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing charge air cooler > < Charge air cooler - exploded view

A3 Mk2

Removing and installing charge pressure senderG31 / intake air temperature senderG42
Removing and installing charge pressure sender -G31- / intake air temperature sender -G42-
   
Removing
–  Remove noise insulation -1- → Rep. gr.50.
  A10-10917
–  Unplug electrical connector -2-.
–  Remove bolts -1- and pull charge pressure sender -G31-/intake air temperature sender -G42- out of air pipe.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Charge air cooler - exploded view“
  Note
Fit new O-ring.
–  Install noise insulation → Rep. gr.50.
  A21-10436

Removing and installing charge air cooler > < Charge air cooler - exploded view