audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing crankshaft oil seal (gearbox end) > < Dual-mass flywheel - exploded view

A3 Mk2

Removing and installing dual-mass flywheel
Removing and installing dual-mass flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -3067-
  W00-0026
Removing
l  Gearbox removed.
  Caution
Make sure dual-mass flywheel is not damaged.
t  Remove bolts -B- using normal hand tools (do not use pneumatic wrench or impact driver, etc.).
t  When removing the bolts, make sure that the bolt heads do not come into contact with the dual-mass flywheel.
t  Rotate the dual-mass flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.
  A30-0102
–  Insert counterhold tool -3067- in hole on cylinder block -item B-, slacken and remove bolts for dual-mass flywheel.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Dual-mass flywheel - exploded view“
  Caution
Make sure friction is sufficient.
Always renew diamond-coated washers → Item and → Item after loosening bolts for dual-mass flywheel.
  Note
t  Renew the bolts tightened with specified tightening angle.
t  Dual-mass flywheel with sender wheel and diamond-coated washers can only be fitted in one position.
–  Insert counterhold -3067- in hole on cylinder block -item A-.
  A13-0051

Renewing crankshaft oil seal (gearbox end) > < Dual-mass flywheel - exploded view