Audi Workshop Service and Repair Manuals

Renewing crankshaft oil seal (gearbox end) Special tools and workshop equipment required

t  Fitting tool -T10122-

t  Extractor tool -T20143/2-

Set up assembly sleeve -T10122/2- as follows: –  Machine drilling for dowel sleeve in assembly sleeve -T10122/2- until dimension -a- = 8 mm.

Procedure l  Gearbox removed. –  Remove dual-mass flywheel → Chapter. –  Pry out oil seal using extractor tool -T20143/2--arrow-. –  Clean contact surface and sealing surface.

–  Fit assembly aid -T10122/1- onto assembly sleeve -T10122/2- and slide oil seal -A- onto assembly sleeve. –  Detach assembly aid.

–  Fit assembly sleeve -T10122/2- with oil seal -1- onto crankshaft.

–  Press in oil seal uniformly until flush all round using thrust piece -T10122/3-. –  Install dual-mass flywheel → Chapter.