Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing crankshaft oil seal >
< Removing and installing dual-mass flywheel
A3 Mk2
Power unit
6-cylinder injection engine (3.2 ltr. 4-valve), mechanics
Enginecrankshaft group, pistons
Cylinder block (gearbox end)
Extracting and driving in needle bearing for crankshaft
Extracting and driving in needle bearing for crankshaft
Extracting and driving in needle bearing for crankshaft
Special tools and workshop equipment required
t
Drift -VW 207 C- or centring mandrel -3176-
t
1 - Internal puller -Kukko 21/1-
t
4 - Counter-support -Kukko 22/1-
t
Depth gauge
Removing
l
Gearbox removed.
–
Remove needle bearing using internal puller -Kukko 21/1- and counter-support -Kukko 22/1-.
Installing
–
Drive in needle bearing using drift -VW 207 C- or centring mandrel -3176-.
l
The inscription on needle bearing must be visible when installed.
Installation position for needle bearing:
l
Dimension
-a-
= 2.0 mm.
Power unit
6-cylinder injection engine (3.2 ltr. 4-valve), mechanics
Enginecrankshaft group, pistons
Cylinder block (gearbox end)
Extracting and driving in needle bearing for crankshaft
Renewing crankshaft oil seal >
< Removing and installing dual-mass flywheel