audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Extracting and driving in needle bearing for crankshaft > < Dual-mass flywheel - exploded view of components

A3 Mk2

Removing and installing dual-mass flywheel
Removing and installing dual-mass flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -T10069-
  W00-1059
Removing
l  Gearbox removed.
–  Mark position of dual-mass flywheel on engine.
  Note
To prevent damage to the dual-mass flywheel when removing, the bolts -B- must not be removed with an impact wrench or similar. The bolts may only be removed by hand using conventional tools.
–  Rotate the dual-mass flywheel -A- so that the bolts align with the holes -arrows-.
–  When unscrewing the bolts, make sure that the bolt heads do not come into contact with the dual-mass flywheel; the flywheel will otherwise be damaged as the bolts are screwed out.
  A30-0102
–  Unbolt dual-mass flywheel (counterhold on vibration damper with tool -T10069-).
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Use new securing bolts.
  N13-0559

Extracting and driving in needle bearing for crankshaft > < Dual-mass flywheel - exploded view of components