A3 Mk2
Air cleaner / engine cover panel - exploded view |
1 - | Air mass meter -G70- |
q | Renewing seal and ensuring that seal is correctly seated → Fig. |
q | Removing and installing → Chapter |
2 - | Bolt |
q | 3 Nm |
3 - | Air cleaner housing (top section/engine cover panel) |
q | Clean any salt deposits or leaves and dirt out of air cleaner housing (top section) |
q | Always follow exact instructions for removal (risk of breaking engine cover panel) |
q | Removing and installing → Chapter |
4 - | Spring-type clip |
5 - | Intake air duct |
q | To air cleaner housing |
q | Clean any leaves and dirt out of intake air duct |
6 - | Filter element |
q | Always use genuine part for air filter element |
q | Removing and installing → Chapter |
q | Observe change intervals → Booklet808 |
7 - | Air cleaner housing (bottom section) |
q | Clean any salt deposits or leaves and dirt out of air cleaner housing (bottom section) |
8 - | Bolt |
q | 3 Nm |
9 - | Heat shield |
10 - | Rubber sleeve |
q | Note assembly markings |
11 - | Air hose |
q | Note assembly markings |
q | To turbocharger |
q | Check air intake hose for dirt and leaves |
|