audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
5-cylinder direct petrol injection engine (2.5 ltr. 4-valve turbo), mechanics > < Removing and installing Hall senderG40

A3 Mk2

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
Special tools and workshop equipment required
   
t  Socket (4 mm) -T10370-
Removing
  W00-10582
–  Remove noise insulation -1- → Rep. gr.66.
  A10-10917
–  Unplug electrical connector -1- at engine speed sender -G28- using assembly tool -T10118-.
  Note
To release electrical connector without assembly tool -T10118-, press connector on engine speed sender in with a screwdriver and at the same time lift release tab with a thin wire hook.
  A23-10423
–  Unscrew securing bolt -arrow- for engine speed sender -G28- using socket -T10370-
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque: refer to overview of fitting locations → Chapter.
–  Install noise insulation -1- → Rep. gr.50.
  N13-10048

5-cylinder direct petrol injection engine (2.5 ltr. 4-valve turbo), mechanics > < Removing and installing Hall senderG40