Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing engine speed senderG28 >
< Removing and installing glow plugs
A3 Mk2
Power unit
TDI injection and glow plug system (4-cyl. 1.6 ltr. 4-valve common rail)
Ignition system, glow plug system / Checking glow plug system
Removing and installing Hall senderG40
Removing and installing Hall senderG40
Removing and installing Hall sender -G40-
–
Remove poly V-belt
→ Rep. gr.13
.
–
Remove vibration damper
→ Rep. gr.13
.
–
Remove toothed belt
→ Rep. gr.15
.
–
Unplug connector
-1-
for Hall sender -G40- and detach connector from retainer.
–
Unbolt Hall sender -G40-
-arrow-
.
–
Using a screwdriver, remove projections and take out cover for repair opening
-arrows-
.
–
Take Hall sender -G40- off cylinder head and guide connector through repair opening in toothed belt cover.
Installing
Install in reverse order. Note the following:
t
Seal repair opening in toothed belt cover with rubber plug; for rubber plug refer to
→ ETKA (Electronic parts catalogue)
.
–
Fit toothed belt and adjust valve timing
→ Rep. gr.15
.
–
Install vibration damper
→ Rep. gr.13
.
–
Install poly V-belt
→ Rep. gr.13
.
Power unit
TDI injection and glow plug system (4-cyl. 1.6 ltr. 4-valve common rail)
Ignition system, glow plug system / Checking glow plug system
Removing and installing Hall senderG40
Removing and installing engine speed senderG28 >
< Removing and installing glow plugs