A3 Quattro L4-2.0L Turbo (CBFA) (2009)
-
Remove the bolt - 1 - and remove the ribbed belt tensioner from the accessory assembly bracket.
Installing
‹› Tightening specifications. Refer to => [ Ribbed Belt Drive Assembly Overview ] See: Drive Belt/Service and Repair/Ribbed Belt Drive Assembly
Overview.
Installation is in reverse order of removal, note the following:
-
Insert the ribbed belt tensioner - 1 - into the accessory assembly bracket - 3 - and tighten the bolt - 5 -.
‹› Note the support - 2 - installation location: insert the support tab in the hole on the accessory assembly bracket.
‹› Note the centering sleeve - 4 -.
-
Install ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belt/Service and Repair/Ribbed Belt.
-
Install After-Run Coolant Pump (V51). Refer to => [ After-Run Coolant Pump ] See: Cooling System/After-Run Coolant Pump/Service and
Repair/After-Run Coolant Pump.
-
Adjust subframe mount. Refer to => [ Subframe Mount, Adjusting ] See: Body and Frame/Frame/Subframe/Front Subframe Mount/Adjustments.