A3 Quattro V6-3.2L (BUB) (2008)
Headlamp Alignment Control Module: Service and Repair
Automatic Headlamp Range Control Module
Automatic Headlamp Range Control Module
Component location: At front of instrument panel carrier in driver side footwell
Removing
-
If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided
Functions".
-
Select the function or path:
-
Follow further instructions on display of VAS 5051B .
-
Remove the driver storage compartment.
-
Disconnect electrical connector - 2 -.
-
Remove screws - 3 - and - 4 - and remove Headlamp Range Control Module J431 - item 1 -.
Installing
Install in reverse order of removal, noting the following:
-
If Headlamp Range Control Module J431 was replaced, it must be re-coded.
-
Select the function or path:
-
Follow further instructions on display of VAS 5051B .
-
Install the driver storage compartment.
Tightening Specifications
Component
Nm
Headlamp Range Control Module J431 to center console
1.3 Nm