A3 Quattro V6-3.2L (BUB) (2008)
/Page-1349001.png)
Fluid - A/T: Service and Repair
Transmission Fluid, Replacing or Filling After Repair
Transmission Fluid, Replacing or Filling after Repair - 6 Spd. Direct Shift A/T 02E All Wheel Drive
Special tools, testers and auxiliary items required
^
Used oil collection and extraction device V.A.G 1782
^
Adapter for oil filling VAS 6262
^
Protective glasses
^
Acid-resistant protective gloves
Note:
^
Rules for cleanliness when working on transmission.
^
General repair notes.
^
Observe notes for direct-shift transmission 02E, Disposal regulations for oils.
CAUTION
^
When working in vicinity of cooler, always ensure clearance to fan - danger of injury!
^
Fan can only switch on by itself.
^
Wear protective glasses.
^
Wear acid-resistant protective gloves.
CAUTION
^
Engine must not be started if there is only a small amount or no transmission oil at all in transmission after a repair or after excessive
outflow of transmission oil.
^
In this case, perform a preliminary filling of transmission fluid for direct-shift transmission.
^
Only transmission fluid for direct shift transmission available as replacement part must be used in the Direct Shift Transmission 02E.
Other oils can cause malfunctions or transmission failure.
Conditions
^
Vehicle on a flat surface
^
Selector lever in position "P".
^
The engine is switched off.
^
The transmission fluid filter must always be replaced when changing the transmission fluid.
Note:
^
Observe all safety precautions, notes and test requirements for "Checking transmission fluid level and topping off".
^
Observe disposal regulations for oils
Gear Oil, Draining
-
Drive vehicle onto a 4-column lift or over a work pit so that it is absolutely level.
-
Replace transmission fluid filter.
-
Remove center noise insulation fasteners -1 to 3-.
-
Place used oil collection and extraction device V.A.G 1782 under transmission.
