A3 Quattro V6-3.2L (BUB) (2008)
CAUTION:
Danger of damaging the paint.
-
Protect the suspension strut dome from scratches with adhesive tape.
-
Turn the wiper arm linkage - 4 - until it is parallel to the body.
-
Disconnect the electrical connector - 5 -.
-
Remove the bolts - arrows -.
-
Pull the wiper frame with the linkage and wiper motor - 1 - far enough forward until the retaining pin - 2 - no longer is inside the mount - 3 -.
-
Remove the wiper frame with linkage and the wiper motor from the plenum chamber.
Installing
Install in reverse order of removal, observing the following:
-
Install the wiper frame - 1 - with linkage and the wiper motor into the plenum chamber; when doing this, the retaining pin - 3 - must fit into the
mount - 4 - on the body - arrow -.
-
Tighten the screws - 2 - and - 5 -.
-
Adjust wiper arms.
Tightening Specifications
Component
Nm
Wiper frame to plenum chamber
8 Nm