A4 Cabriolet Mk2
| Removing and installing backrest cover and padding |
| 1 - | Backrest cover |
| Removing |
| – | Remove seat → Chapter. |
| – | Remove backrest → Chapter. |
| – | Remove outer parts of both seat belt guides → Fig.. |
| – | Prise cover off belt guide, drill out pop rivets with Ø 5.0 mm bit and detach belt guide → Fig.. |
| – | Prise fastening strip off guide on backrest -6- all around edge of backrest cover -1- → Fig.. |
| – | In bended sections, fastening strip is additionally secured with retaining clips -3-; carefully remove retaining clips. |
| – | Carefully detach seams of backrest cover from Velcro joint on backrest padding -4-. |
| – | Disengage retaining strip at bottom of pneumatic block -5-. |
| – | Remove backrest cover. |
| Installing |
| Install in reverse order of removal. |
| 2 - | Outer section of belt opening |
| q | Removing and installing → Fig. |
| 3 - | Retaining clips (8x) |
| q | For fastening strip on backrest cover |
| q | Install in bended area of backrest |
| 4 - | Backrest padding |
| Removing |
| – | Remove backrest cover -1-. |
| – | Disengage flaps for backrest bolster adjustment -7- from retaining bracket on backrest → Fig.. |
| – | Disconnect pneumatic hose for backrest bolster adjustment |
| – | Detach backrest padding from backrest. |
| Installing |
| Install in reverse order of removal. |
| 5 - | Pneumatic block |
| Removing |
| – | Remove backrest cover -1-. |
| – | Remove backrest padding -4-. |
| – | Carefully detach pneumatic block from backrest (glued together). |
| – | Swivel pneumatic block forwards at upper edge. |
| – | Move wiring harness clear. |
| – | Remove pneumatic block. |
| Installing |
| Install in reverse order of removal. |
| – | If necessary, renew double-sided adhesive tape → Parts catalogue. |
| q | Pneumatic block: assignment → Chapter |
| 6 - | Backrest |
| q | Removing and installing → Chapter |
| 7 - | Belt guide |
| q | Removing and installing → Fig. |
| 8 - | Trim |
| q | For belt guide |
| q | Removing and installing → Fig. „„Removing and installing belt guide““ |
| 9 - | Pop rivet |
| 10 - | Flap for backrest bolster adjustment |
| q | Disengaging → Fig. |
|
|
|
|
|
|
