t
| If display zone -1- indicates “Disabled” and disable time (e.g. “10” for 10 minutes), the adaption function is currently not available due to having been incorrectly implemented several times. |
t
| Wait for completion of disable time. |
t
| If zone -1- displays “Bus n. OK”, the ignition may have been switched off or there is a fault in the convenience data bus system or the control unit in dash panel insert -J285-. |
Indicated on display of vehicle diagnostic, testing and information system -VAS 5051A-: |
t
| Display zone -1- indicates “Channel 81 reading and testing”. |
t
| Display in area -2- is “PIN ?”. |
t
| A bar appears in area -3- (not to be used for this application). |
–
| Touch key -4- (for entry via keypad). |
Indicated on display of vehicle diagnostic, testing and information system -VAS 5051A-: |
t
| Display zone -1- indicates “Enter adaption value: 0....XXXXX”. |
t
| Input keypad appears in display zone -2-. |
–
| Use input keypad in display zone -2- to enter PIN for re-adaption of auxiliary heater control unit -J364-. |
t
| PIN entered appears in area -2-. |
–
| Confirm entry by touching Q key. |
Note Depending on the version of the auxiliary heater control unit -J364-, “Wait” may now briefly appear on the display of the vehicle diagnostic, testing and information system -VAS 5051A-. |
Indicated on display of vehicle diagnostic, testing and information system -VAS 5051A-: |
t
| The PIN entered appears above the bar in area -3-. |
–
| Store entry by touching key -5-. |
|
|
|