Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Checking gear lever adjustment >
< Removing and installing selector mechanism
A4 Cabriolet Mk2
Power transmission
6-speed manual gearbox 01E, four-wheel drive
Gearbox mechanics,operation, construction,diff. / Servicing selector mechanism
Adjusting selector mechanism
Adjusting selector mechanism
Adjusting selector mechanism
The following are prerequisites for correct gear lever alignment:
l
Gear selector linkage must be in proper condition and undamaged.
l
Selector mechanism must move freely.
l
Gearbox, clutch and clutch mechanism must be in proper condition.
l
Gearbox in neutral.
Procedure
–
Remove gear knob together with boot
→ Chapter
.
Vehicles with large radio slot:
–
Remove operating and display unit for air conditioner
→ Rep. Gr.87
.
Vehicles with small radio slot:
–
First lift trim panel
-1-
in direction of
-arrow A-
, then pull it out in direction of
-arrow B-
.
All models:
–
Unscrew bolts
-arrows C-
and then pull ashtray
-2-
out of centre console.
–
Unplug electrical connector for ashtray light.
–
Remove foam wedges from centre console.
–
Lift out the noise insulation.
–
Unscrew noise insulation for selector housing
-arrows-
.
–
Measure distance
-a-
between the two studs in the selector mechanism.
l
Specification: distance
-a-
= 85 mm.
Note
Measure from centre of one stud to centre of the other.
If distance
-a-
does not meet specification:
–
Loosen bolt
-arrow-
for push rod.
l
Rear push rod (in selector mechanism) should move freely in both directions on slide.
–
Set to distance
-a-
by moving rear push rod (in selector mechanism).
–
Tighten bolt for push rod
-arrow-
to 23 Nm.
–
Loosen bolt for selector rod
-arrow-
.
l
Connection between selector rod and selector mechanism should move freely.
Align the gear lever as follows:
–
Centre the bottom of the gear lever in the centre of the ball guide.
l
Distance between ball guide and bottom of gear lever
-arrows-
must be the same at all points.
–
Align gear lever so that it points slightly (3°) to the right (as seen in direction of travel).
–
Hold gear lever in this position.
–
Tighten bolt for selector rod
-arrow-
to 23 Nm.
Note
The gear lever must remain in the same position while the bolt is being tightened.
Power transmission
6-speed manual gearbox 01E, four-wheel drive
Gearbox mechanics,operation, construction,diff. / Servicing selector mechanism
Adjusting selector mechanism
Checking gear lever adjustment >
< Removing and installing selector mechanism