A4 Cabriolet Mk2
Exploded view - clutch hydraulics |
1 - | Brake fluid reservoir |
2 - | Supply hose |
q | For clutch master cylinder |
3 - | Pipe/hose assembly |
q | For plug-in connections on clutch master cylinder and slave cylinder |
q | Disconnecting from clutch master cylinder and installing → Anchor |
q | Disconnecting from clutch slave cylinder → Fig. |
q | Refer to → Parts catalogue for correct version for LHD and RHD vehicles |
4 - | Grommet |
5 - | Mounting bracket |
6 - | Clutch pedal |
7 - | Clutch master cylinder |
q | Removing and installing → Chapter |
q | Do not remove clip -arrow A- or seal -arrow B-. |
q | To remove pipe/hose assembly, pull out clip -arrow A-, but only as far as limit stop → Anchor. |
8 - | Hexagon socket head bolt, 20 Nm |
9 - | Retaining clip |
q | Only renew when clutch master cylinder has been removed |
q | Lever off to remove → Fig. |
q | Push in to install → Fig. |
10 - | Gearbox |
11 - | Clutch slave cylinder |
q | Do not operate clutch pedal after slave cylinder has been removed. |
q | Removing and installing → Chapter |
q | Bleed clutch slave cylinder after working on hydraulic clutch mechanism → Chapter |
q | Disconnecting pipe/hose assembly → Fig. |
q | Do not allow brake fluid to come into contact with gearbox. |
12 - | Bleeder valve |
q | Tighten to 4.5 Nm |
q | Follow correct procedure when bleeding → Chapter „Bleeding clutch system“ |
q | If bleeder valve has broken off, it can be removed with 3 mm Allen key |
13 - | Dust cap |
14 - | Clip |
q | To remove pipe, pull out clip as far as limit stop → Fig. |
15 - | Bracket |
q | For pipe/hose assembly |
q | Attached to gearbox together with slave cylinder |
16 - | Hexagon socket head bolt, 25 Nm |
q | Clutch slave cylinder to gearbox |
q | Self-locking |
q | Renew |
17 - | Retaining clip |
18 - | Seal |
19 - | Securing bolt |
q | For brake fluid reservoir |
|
|