Installation is carried out in reverse sequence; note the following: |
–
| Fit multifunction switch -F125- onto selector shaft. The flat surface in the splines of the switch -3- must coincide with the flat surface on the selector shaft -1-. |
Note Fit the multifunction switch -F125- centrally on the selector shaft. Take care to keep it straight and do not use excessive force. This could damage the switch contacts. |
–
| Turn switch so that drilling -4- on switch housing can be fitted on locating pin -2- on gearbox housing. |
–
| Install gearbox support (left-side) → Chapter. |
|
|
|