audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox input speed sender G182 > < Removing and installing multifunction switch F125

A4 Cabriolet Mk2

Removing and installing speedometer senderG22
Removing and installing speedometer sender -G22-
   
Removing
–  Remove front left wheel.
–  Vehicles with 2.5 ltr. TDI engine: detach drive shaft noise insulation (left-side) from wheel housing -arrows-.
  N37-0481
–  Remove heat shield for drive shaft (left-side) -arrows-.
  Note
The third bolt is not shown in the illustration.
  A34-0138
–  Unplug electrical connector -arrow A- for speedometer sender -G22- on gearbox.
  Note
-Arrow B- can be disregarded.
–  Push down the retaining clip holding the sender, turn it, and pull out the sender.
  A38-0096
Installing
Installation is carried out in reverse sequence; note the following:
  Note
Renew O-rings
–  Lightly lubricate O-rings -arrows- with ATF before installation to prevent them being trapped during assembly.
–  Fit sender and engage retaining clip on bearing bracket for flange shaft.
–  Install front left wheel → Rep. Gr.44.
Tightening torque
  A38-0017
ComponentNm
Heat shield for drive shaft to gearbox23

   

Removing and installing gearbox input speed sender G182 > < Removing and installing multifunction switch F125