Audi Workshop Service and Repair Manuals

Removing and installing selector lever cable on vehicles with 2.0 ltr. TFSI engine with vehicle ID No. up to 8E_8A 002699 Removing –  Shift selector lever to position “P”.

–  Open quick release fasteners -2- and -3- and take off rear noise insulation.

–  Pry ball socket -1- of selector lever cable off selector shaft lever. –  Unscrew support bracket from gearbox -arrows-.   Note Shown in illustration with gearbox support removed.

–  Unbolt heat shield -A- for propshaft -arrows-.

–  Remove heat shield -1- for exhaust system below selector mechanism -arrows-. –  Unscrew bolts at gearbox/propshaft flange. –  Push propshaft -2- together towards rear final drive. The constant velocity joints can be moved axially.

–  Tie propshaft up to side onto heat shield -arrow-. –  If fitted, remove heat shield under selector mechanism → General body repairs, exterior; Rep. Gr.66.

–  Remove selector lever cable sleeve from selector mechanism cover (bottom) and slide back. –  Unscrew cover on underside of selector mechanism -arrows-.

–  Remove retaining clip -1- for selector lever cable by pulling it off downwards at the selector mechanism. –  Pull plastic securing spring -2- slightly forwards and press pin -3- upwards, but only as far as is necessary -arrow-.   Note Ensure that pin is not pressed out completely. –  Pull selector lever cable -4- out of selector mechanism.   Note Do not bend or kink the selector lever cable.

Installing Installation is carried out in reverse sequence; note the following: l  Tightening torques → Chapter „Exploded view - selector lever cable and locking cable on vehicles with vehicle ID No. up to 8E_8A 002699“ and → Chapter „Exploded view - dismantling and assembling selector mechanism on vehicles with vehicle ID No. up to 8E_8A 002699“ –  Shift selector lever to position “P”. –  Fit new retaining clip -1- for selector lever cable on selector mechanism. l  Installation position: The angled end of the retaining clip faces to the inside of the selector mechanism. –  Insert end of selector lever cable -4- in joint on selector lever. –  Push pin -3- down -arrow-. –  Check that plastic securing spring -2- has locked the pin.

–  Secure cover to underside of selector mechanism -arrows-. –  Attach sleeve for selector lever cable to selector mechanism cover (bottom). –  Shift selector lever from position “P” to “S”. l  Selector mechanism and selector lever cable must move freely. If necessary renew selector lever cable or service selector mechanism.   Note Do not bend or kink the selector lever cable. –  Shift selector lever to position “P”.

–  Press selector shaft lever -1- on gearbox towards the rear as far as it will go -arrow- until parking lock engages.   Note When the parking lock has engaged it should no longer be possible to rotate both front wheels in one direction. –  Make sure that the selector lever cable has not been bent or kinked and that it is not under tension.

–  Carefully press selector lever cable -1- onto ball head of selector shaft lever.   Note Make sure you do not bend the selector shaft lever when pressing on the cable, as this would make it impossible to obtain an accurate adjustment of the selector mechanism. –  Bolt on the support bracket for selector lever cable -arrows-. –  Adjust selector lever cable → Chapter „Checking and adjusting selector lever cable on vehicles with vehicle ID No. up to 8E_8A 002699“. –  Bolt propshaft onto gearbox → Rear final drive 01R; Rep. Gr.39. –  Install exhaust system so it is free of stress → Rep. Gr.26.