A4 Cabriolet Mk2
Note
| 1 - | Selector lever cable |
| q | → Chapter „Checking and adjusting selector lever cable on vehicles with vehicle ID No. up to 8E_8A 002699“ |
| q | Must not be kinked |
| q | → Chapter „Removing and installing selector lever cable on vehicles with 2.0 ltr. TFSI engine with vehicle ID No. up to 8E_8A 002699“ |
| q | → Chapter „Removing and installing selector lever cable on vehicles with 3.2 ltr. FSI engine with vehicle ID No. up to 8E_8A 002699“ |
| q | → Chapter „Removing and installing selector lever cable on vehicles with 4.2 ltr. MPI engine with vehicle ID No. up to 8E_8A 002699“ |
| q | → Chapter „Removing and installing selector lever cable on vehicles with 3.0 ltr. TDI engine with vehicle ID No. up to 8E_8A 002699“ |
| 2 - | Retaining clip |
| q | Secures selector lever cable to support bracket |
| q | Renew |
| 3 - | Sleeve for selector lever cable |
| q | Press into selector mechanism cover (bottom). |
| 4 - | Retaining clip |
| 5 - | Ignition/starter switch |
| q | With ignition key removal lock |
| 6 - | Locking cable for ignition key removal lock |
| q | Must not be kinked |
| q | → Chapter „Removing and installing locking cable on vehicles with vehicle ID No. up to 8E_8A 002699“ |
| q | → Chapter „Adjusting locking cable on vehicles with vehicle ID No. up to 8E_8A 002699“ |
| 7 - | Hexagon bolt, 9 Nm |
| 8 - | Clamping bolt for selector lever cable, 13 Nm |
| q | Loosen 1 turn for adjusting, do NOT remove completely |
| 9 - | Pin for selector lever cable |
| q | To remove selector lever cable, pull plastic securing spring on selector mechanism forwards slightly and push up pin just far enough to release cable. |
| 10 - | Retaining clip |
| q | For selector lever cable |
| q | Renew |
| 11 - | Support bracket |
| q | Secures selector lever cable to gearbox |
| 12 - | Hexagon bolt, 10 Nm |
