audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing wiring harness in gearbox > < Removing and installing gearbox input speed sender G182 - gearbox with hydraulic control type "E17”

A4 Cabriolet Mk2

Removing and installing gearbox input speed senderG182 - gearbox with hydraulic control type “E18/2”
Removing and installing gearbox input speed sender -G182- - gearbox with hydraulic control type “E18/2”
  Note
t  On gearboxes with hydraulic control system type “E18/2”, the gearbox input speed sender -G182- is a Hall sender and is fixed to the gearbox housing behind the valve body.
t  For allocation of hydraulic control system refer to technical data → Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.00.
   
Removing
–  Remove valve body → Chapter.
–  Unscrew bolt -B-.
–  Detach gearbox input speed sender -G182--item A- from gearbox.
Installing
Installation is carried out in reverse sequence; note the following:
–  Clip electrical connector -C- for gearbox input speed sender -G182- into valve body mounting after installing valve body.
–  Install valve body → Chapter.
–  Fill up with ATF → Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.37.
Tightening torque
  A38-0086
ComponentNm
Gearbox input speed sender -G182- to gearbox9

   

Removing and installing wiring harness in gearbox > < Removing and installing gearbox input speed sender G182 - gearbox with hydraulic control type "E17”