A4 Cabriolet Mk2
Exhaust system (rear section) - exploded view of components |
1 - | Centre silencer |
q | Combined in one unit with rear silencer as original equipment. Can be renewed individually for repair purposes |
q | Cutting point → Anchor |
q | Align exhaust system so it is free of stress → Chapter |
2 - | 25 Nm |
q | Renew |
3 - | Mounting |
q | Renew if damaged |
q | Check preload → Chapter „Stress-free alignment of exhaust system“ |
4 - | Mounting |
q | Renew if damaged |
q | Check preload → Chapter „Stress-free alignment of exhaust system“ |
5 - | Clamp, 25 Nm |
6 - | Tailpipe |
q | Renewing → Chapter |
7 - | Mounting |
q | Renew if damaged |
q | Check preload → Chapter „Stress-free alignment of exhaust system“ |
8 - | 25 Nm |
9 - | Rear silencer |
q | Combined with front silencer as original equipment. Can be renewed individually for repair purposes |
q | Cutting point → Anchor |
q | Align exhaust system so it is free of stress → Chapter |
10 - | Clamp (rear) |
q | For separate replacement of centre and rear silencers |
q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
q | Installation position → Fig. |
q | Tighten bolt connections evenly |
11 - | M8 = 23 Nm; M10 = 40 Nm |
12 - | 25 Nm |
13 - | Mounting |
q | Renew if damaged |
q | Check preload → Chapter „Stress-free alignment of exhaust system“ |
14 - | From main catalytic converter |
|