audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head cover > < Cylinder head - exploded view

A4 Cabriolet Mk2

Removing and installing camshaft control valve 1N205
   
Removing and installing camshaft control valve 1 -N205-
Special tools and workshop equipment required
t  Torque wrench -V.A.G 1783-
t  Torx bit set -V.A.G 1766-
t  Ratchet insert 1/4" -VAS 6234-
t  Spring type clip pliers -VAS 5024 A-

Removing
  Note
Always renew seals and gaskets.
   
–  Pull off engine cover panel -arrows-.
  A10-10292
–  Unplug electrical connector -1-.
–  Detach bracket for wiring harness -arrow-.
  Note
Do not pull on electrical connector when removing camshaft control valve 1 -N205-.
  A10-10402
–  Remove bolts -arrows- and take camshaft control valve 1 -N205- out of housing.
Installing
l  Tightening torques → Chapter „Cylinder head - exploded view“
  Note
t  Make sure the camshaft control valve 1 -N205- and the housing are free from any kind of dirt.
t  Do not remove camshaft control valve 1 -N205- from packaging until you are ready to install it.
  Caution
Do not expose the camshaft control valve 1 -N205- to shock impacts.
–  Lubricate the seal with engine oil.
–  Carefully fit camshaft control valve 1 -N205- into housing and press in by hand as far as the stop (exert pressure in line with axis of valve).
–  Screw in and tighten bolts using torque wrench -V.A.G 1783- and ratchet insert 1/4" -VAS 6234- and Torx bit T20 and bit holder from Torx bit set -V.A.G 1766-.
Further assembly is basically carried out in reverse order of dismantling.
  A10-10403

Removing and installing cylinder head cover > < Cylinder head - exploded view