A4 Cabriolet Mk2
| Sealing flanges and dual-mass flywheel / flywheel - exploded view |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | Engine speed sender -G28- |
| q | Removing and installing → Chapter „Renewing rear sealing flange“ |
| 2 - | 4.5 Nm |
| 3 - | 15 Nm |
| 4 - | Oil seal |
| q | Renewing → Chapter |
| 5 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Apply sealant when installing; refer to → Electronic parts catalogue |
| q | Removing and installing → Chapter |
| 6 - | 15 Nm |
| q | Tighten in stages and in diagonal sequence |
| 7 - | Sump |
| q | Removing and installing → Chapter |
| 8 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 9 - | Dual-mass flywheel / flywheel |
| q | Dual-mass flywheel for vehicles with manual gearbox |
| q | Removing and installing dual-mass flywheel → Chapter |
| q | Flywheel for vehicles with multitronic gearbox |
| q | Removing and installing flywheel → Chapter |
| 10 - | Securing bolt for dual-mass flywheel/flywheel |
| q | Renew |
| q | Tightening torque: vehicles with manual gearbox → Chapter; vehicles with multitronic gearbox → Chapter |
| 11 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| 12 - | Sender wheel |
| q | For engine speed sender -G28- |
| q | Removing and installing → Chapter „Renewing rear sealing flange“ |
| 13 - | 15 Nm |
| 14 - | Sealing flange (rear) with oil seal |
| q | Renewing → Chapter |
|
|
