audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Installation position of high-pressure injectors, air guides, high-pressure pump, coolant pipe > < Low-pressure/high-pressure lines at fuel rail, high-pressure pump and load motion flap for air flow control

A4 Cabriolet Mk2

Motronic Direct Injection and Ignition System (4-Cyl.)
Servicing injection system
Throttle valve control unit, exhaust-gas recirculation valve on intake manifold
 
A24-0530
  • Combi bolt (4x), 9 Nm
  • Connection
  • Gasket
  • Exhaust-gas recirculation valve (servomotor); adaption to engine control unit required after replacement (Basic setting, Display group 74 with ignition switched on; see "Assisted fault-finding").
 
A24-0530
  • Gasket
  • Cap
  • Throttle valve control unit
    • ◆ Adaption to engine control unit required after replacement (Basic setting, Display group 60; see "Assisted fault-finding").
  • Bolt (4x), 5 Nm plus 180 degrees (half turn)
 
A24-0530
  • Hose
  • Spring clip
  • Intake manifold
  • Hose
  • Bolt, 3 Nm
  • Exhaust-gas recirculation line
  • Bolt (2x), 9 Nm
  • Bolt, 9 Nm

Installation position of high-pressure injectors, air guides, high-pressure pump, coolant pipe > < Low-pressure/high-pressure lines at fuel rail, high-pressure pump and load motion flap for air flow control