Audi Workshop Service and Repair Manuals

Renewing bush for track control link

Special tools and workshop equipment required

t	Assembly tool -3301-

t	Assembly tool -3301/3-

t	Assembly tool -3301/4-

t	Assembly tool -3346-

t	Assembly tool -3346/1-

t	Assembly tool -3346/2-

t	Assembly tool -3346/3-

t	Assembly tool -3350/1-

Note Always use protective jaws when clamping aluminium links in a vice.

Removing inner bush –  Mark position of old bush.

Installation position of bush –  Transfer markings for installation position from old bush to new bush.

Installing inner bush –  Insert bush -A- in 3.2 mm recess in thrust piece -3346/1-. –  Pull in bush as far as the stop.

Removing outer bush

Installing outer bush Use assembly lubricant G 294 421 A1 diluted with water (ratio 1:100) when pressing in bush. –  Pull in bush so it fits centrally. Chamfers on bush and on track control link must face each other.