Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Vehicles with 2.4 ltr. and 3.0 ltr. MPI engine >
< Removing and installing starter
A4 Cabriolet Mk2
Vehicle electrics
Electrical system / Starter-current supply-CC
Removing and installing starter
Vehicles with 1.8 ltr. turbo and 2.0 ltr. MPI engine
Vehicles with 1.8 ltr. turbo and 2.0 ltr. MPI engine
Vehicles with 1.8 ltr. turbo and 2.0 ltr. MPI engine
Removing
–
With ignition switched off, disconnect earth cable at battery
→ Chapter
.
–
On vehicles with auxiliary heater, unscrew bolts
-arrows-
for exhaust pipe of auxiliary/supplementary heater at noise insulation.
–
Unfasten bolts/quick-release fasteners
-1-
and
-2-
and detach noise insulation (front).
–
Unscrew wire for terminal B+
-item 2-
.
–
Unplug electrical connector for terminal 50
-item 1-
.
–
If fitted, detach insulator at positive connection for starter.
–
Unscrew wiring clamp
-4-
.
–
Unscrew bracket for starter at cylinder block
-3-
and starter.
–
Remove bolts
-1-
and
-2-
.
–
Guide starter downwards and remove.
Installing
Installation is carried out in the reverse order; note the following:
–
Connect battery. Steps required
→ Anchor
.
Tightening torques
Component
Nm
Starter
M10
45
to gearbox
M12
65
Terminal B+ to starter
16
Vehicle electrics
Electrical system / Starter-current supply-CC
Removing and installing starter
Vehicles with 1.8 ltr. turbo and 2.0 ltr. MPI engine
Vehicles with 2.4 ltr. and 3.0 ltr. MPI engine >
< Removing and installing starter