→ If the pinion shaft and crown wheel have to be adjusted, the following sequence is recommended as the most efficient:
1.)
|
Determine total shim thickness "Stotal" for "S1" + "S2" (sets preload for taper roller bearings for differential) => from Page 39-59.
|
2.)
|
Determine total shim thickness "Stotal" for "S3" + "S4" (sets preload for taper roller bearings for pinion shaft) => from Page 39-43.
|
3.)
|
Distribute total shim thickness "Stotal" for "S3" + "S4" so that the distance from centre of crown wheel to face of pinion shaft is the same as distance "R" which was determined during production => from Page 39-51.
|
4.)
|
Distribute total shim thickness "Stotal" for "S1" + "S2" so that the specified backlash exists between crown wheel and drive pinion => from Page 39-67.
|
Note:
Overview of components and shims =>Page 39-38.
|