Audi Workshop Service and Repair Manuals

Notes:

• ◆ Lubricate bearings and moving surfaces with polycarbamide grease, part no. G 052 142 A2.
• ◆ Adjust shift mechanism:
  =>Page 34-8.

• Release and tighten bolt -23 Nm
• Selector rod
• ◆ With selector joint
• Bushing
• ◆ Installation position: The rounded end faces the gear stick
• Spring

• Ball stop
• ◆ Insert spring and bush in the ball stop and assemble on the gear stick so that the spring and bush are on the right when looking forwards.
• ◆ Install ball stop before fitting circlip (Item 21).
• Spring
• Spacer bush
• Circlip
• ◆ Do not open out too far when fitting
• Sealing collar
• Bushing
• Cross head bolt

• Retaining frame - lower section
• Retaining frame - upper section
• Cover
• ◆ Retaining hook on rear of cover, prise out carefully from centre console
• Bushing
• Gear stick knob
• Gear stick
• ◆ Can only be fitted into ball housing in one position
• Nut - 23 Nm
• Spacer tube
• Connector

• Circlip
• ◆ Replace
• ◆ Remove before removing the ball stop
• ◆ Installation position: rounded side faces ball housing (Item 22)
• Ball housing
• ◆ Limit pieces for ball stop on left and right must be engaged.
• ◆ Installation position: reverse detent faces left
• Buffer
• Nut - 10 Nm
• Housing for shift mechanism

• Bellows
• ◆ Remove heat shield before remo-ving and installing
• ◆ Pull carefully over selector rod
• Nut - 10 Nm
• ◆ Self-locking
• ◆ Replace
• Bolt
• Selector fork
• Release and tighten bolt -23 Nm
• ◆ Before slackening bolt, take off and push back heat shield
• Clamp