audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Sequence of readjustment of final drive > < Position of shims

A4 Mk1

5-Speed Manual Gearbox 01A (4WD)
Adjusting drive pinion and crown wheel
Adjustment overview

Note:

If repairs have been carried out on the gearbox it is only necessary to adjust the pinion shaft, crown wheel or final drive set if components have been renewed which have a direct effect on the adjustments of the final drive. To eliminate unnecessary adjustments observe following table:

To adjust:


Parts renewed:
▼

Crown wheel
"S1"+"S2" 1)

Pinion shaft
"S3"+"S4" 1)
using deviation "r"
=> Page 39-46

Pinion shaft
"S4" 1)


=> Page 39-61

Backlash
Testing

=> Page 39-70

Gearbox housing 3)

X

X

X

Gearbox cover

X

Differential housing

X

X

Double taper roller bearing for drive pinion in hollow shaft

X

X

Taper roller bearing for differential

X

X

Final drive set 2)

X

X

X

Final drive cover

X

X

1)    Shims; installation position => Page 39-43.

2)    Drive pinion and crown wheel; only replace together.

3)    If the gearbox housing is renewed then the input shaft also needs to be adjusted => Page 35-18, adjusting input shaft.

Sequence of readjustment of final drive > < Position of shims