Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing gearbox input speed sender G182 - gearbox with hydraulic control type "E17” >
< Removing and installing internal oil pipe
A4 Mk1
Power transmission
Servicing automatic gearbox 01V, front-wheel drive and four-wheel drive
Automatic gearbox, gears, control
Performing servicing work with gearbox installed
Removing and installing gearbox speed sender G38 / gearbox output speed sender G195
Removing and installing gearbox speed senderG38/gearbox output speed senderG195
Removing and installing gearbox speed sender -G38-/gearbox output speed sender -G195-
Removing
–
Drain ATF
→ Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.37
.
–
Remove ATF oil pan
→ Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.38
.
–
Unplug electrical connector
-arrow-
for gearbox speed sender -G38-/gearbox output speed sender -G195-.
–
Unscrew bolt and remove gearbox speed sender -G38-/gearbox output speed sender -G195-
-item 2-
with spacer bush
-1-
.
Installing
Installation is carried out in reverse sequence; note the following:
–
Fit gearbox speed sender -G38-/gearbox output speed sender -G195-
-item 2-
with spacer bush
-1-
to gearbox and tighten bolt.
l
Length of spacer bush: 8 mm.
–
Install ATF oil pan
→ Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.38
.
–
Fill up with ATF
→ Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.37
.
Tightening torque
Component
Nm
Gearbox speed sender -G38-/gearbox output speed sender -G195- to gearbox
6
Power transmission
Servicing automatic gearbox 01V, front-wheel drive and four-wheel drive
Automatic gearbox, gears, control
Performing servicing work with gearbox installed
Removing and installing gearbox speed sender G38 / gearbox output speed sender G195
Removing and installing gearbox input speed sender G182 - gearbox with hydraulic control type "E17” >
< Removing and installing internal oil pipe