A4 Mk1
Poly V-belt drive for alternator, power steering pump and viscous fan - exploded view |
1 - | 10 Nm |
2 - | Fan wheel for viscous fan |
3 - | Circlip |
q | For viscous fan bearing |
q | Removing and installing → Chapter |
4 - | Poly V-belt |
q | Check for wear |
q | Do not kink |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
q | Removing and installing → Chapter |
q | When installing, make sure it is properly seated on pulleys. |
5 - | Special bolt, 10 Nm + 90° (1/4 turn) further |
6 - | Vibration damper with poly V-belt pulley |
q | Can only be installed in one position |
q | Removing and installing → Chapter |
7 - | Poly V-belt pulley for viscous fan |
q | Removing and installing → Chapter „Removing and installing viscous fan“ |
8 - | 23 Nm |
9 - | Tensioner for poly V-belt |
q | Turn with open-end spanner to slacken poly V-belt → Chapter |
q | Secure in fixing holes with suitable Allen key or locking pin |
q | Removing and installing → Chapter „Removing and installing bracket for ancillaries“ |
10 - | 46 Nm |
11 - | Bearing for viscous fan |
q | Removing and installing → Chapter |
12 - | Bracket for ancillaries |
q | Removing and installing → Chapter |
13 - | 23 Nm |
14 - | Alternator |
q | Removing and installing → Rep. Gr.27 |
15 - | 45 Nm |
16 - | Support for intake manifold |
17 - | 20 Nm |
18 - | 52 Nm |
q | Install using locking fluid; for locking fluid refer to → Parts catalogue |
q | Different bolt lengths. Allocation and tightening sequence → Anchor |
19 - | 23 Nm |
20 - | Power steering pump |
q | Removing and installing → Rep. Gr.48 |
21 - | 23 Nm |
22 - | Poly V-belt pulley for power steering pump |
q | Installation position: shoulder faces to front of vehicle |
23 - | 23 Nm |
24 - | Ribbed bolt, 28 Nm |
25 - | Viscous coupling |
q | Removing and installing → Chapter „Removing and installing viscous fan“ |