|
Navigation system I (route navigation) (up to CW 28/99)
Starting the navigation system
The navigation system can be started once the calibration program has been exited.
Display:
|
|
|
|
SERV. MENU:
SET WHLS
WIRING
DRIVE TST
SYS. TEST
> END
|
|
-
‒ Select the menu item "END" with the cursor keys and confirm the selection with the "ENTER" key.
|
CHECK:
A4 - SAL - B5
TYRE:
205/60 16
|
|
|
> YES
NO
|
|
-
‒ If the selection is confirmed with the "ENTER" key, the program continues with the relevant menu item.
-
‒ If the selection is not confirmed with the "ENTER" key, the following instruction appears:
Display:
|
CARRY OUT
WHEEL
CALIBRATION
|
|
|
> OK
|
|
-
‒ Confirm the display OK with the "ENTER" key.
Display:
|
|
|
|
PLEASE
INSERT
NAVIGATION-
CD NOW.
> OK
|
|
-
‒ If you have not already done so, insert navigation system CD in CD-ROM drive and confirm with OK.
The navigation program is automatically loaded and started.
Display:
|
NAV. SYS. MENU:
|
|
|
NO DESTINATION
AVAILABLE.
* START
> SELECTION↓
|
|
Note:
The language is automatically loaded or, if required, can be loaded directly from the navigation system basic menu => Operating instructions.
The location can be entered manually during the navigation system test drive required by customer service .
It can, however, also be left to the navigation system to determine the location. To this end the vehicle must be driven a few kilometres along a route with as many bends and junctions as possible.
The navigation system then automatically determines the location.
| 
