audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing guide > < Removing and installing bumper (front)

A4 Mk2

Securing bumper to impact damper
Securing bumper to impact damper
Up to VIN 400 000
  Note
t  The impact damper is self-adjusting, i.e. it can compensate for differences in height between the bumper and the impact damper when the hexagon socket head bolt is screwed in.
t  This means that the front bumper is automatically held in the position adjusted before and secured when the hexagon socket head bolts -1- are screwed in.
t  Vehicles with VIN 400 001 or higher no longer have the self-adjusting height compensation feature.
   
1 - Hexagon socket head bolt
q   23 Nm
2 - Drive bush (bottom)
q   Plastic part pressed into adjuster screw
q   Not available as a separate replacement part
3 - Adjuster screw (bottom)
q   Screw in completely before installing bumper, but do not tighten
q   Left-hand thread
q   Not available as a separate replacement part
4 - Threaded bush (bottom)
q   Secured with locating pin to prevent it from dropping out
q   Not available as a separate replacement part
5 - Locating pin
q   Not available as a separate replacement part
6 - Impact damper
q   Removing and installing → Chapter.
7 - Threaded bush (top)
q   Secured with locating pin to prevent it from dropping out
q   Not available as a separate replacement part
8 - Adjuster screw (top)
q   Screw in completely before installing bumper.
q   Right-hand thread
q   Not available as a separate replacement part
9 - Cover
q   Removing and installing → Chapter.
10 - Nut
q   Supplied together with cross member
11 - Drive bush (top)
q   Plastic part pressed into adjuster screw
q   Not available as a separate replacement part
12 - Cross member
q   Removing from cover/installing → Chapter

   

Removing and installing guide > < Removing and installing bumper (front)