audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Preparations before installing a new window > < Exploded view - removing and installing side window
Removing undamaged side window
Removing undamaged side window
  WARNING
Always wear safety goggles and leather gloves when removing window.
Remove the following trim panels:
–  Luggage compartment side trim
–  D-pillar trim
–  Trim above rear side window
–  C-pillar trim
   
–  Pull trim panel for C-pillar towards front off rear side window -arrows-.
Side window (high-gloss package)
  A64-0213
–  Starting at C-pillar, pull bottom of trim strip -1- out of retaining springs -2-.
–  Disengage trim strip (bottom) from roof trim strip.
  WARNING
t  To prevent paintwork damage when removing and installing trim strip, always mask area beneath side window and on side panel with adhesive tape.
t  Even a slightly bent roof trim strip is damaged and must be renewed.
All models:
  A64-0214
–  Pierce adhesive bead using trimming needle and handle from -V.A.G 1755-.
–  Unscrew handle and thread cutting wire into eye of trimming needle.
  A64-10031
–  Pull one end of cutting wire -A- into vehicle interior as far as opposite side of window using trimming needle from -V.A.G 1755- (use pliers and protective gloves).
  A64-10032
–  Pull in cutting wire -B- beneath moulded PU trim of side window.
  A64-10033
–  Position cutting wire all around window.
–  Pierce adhesive bead using trimming needle and handle from -V.A.G 1755-.
–  Unscrew handle and thread end of cutting wire -B- into eye of trimming needle.
–  Pull end of cutting wire -B- into interior of vehicle using trimming needle (use pliers and protective gloves).
–  Attach end of cutting wire -B- to bracket for belt guide.
  A64-10034
–  Attach reel -V.A.G 1654- as shown and secure cutting wire in it.
  A64-10035
–  Cut out first section at C-pillar and at bottom of window.
  Note
Press cutting wire towards body while cutting.
  A64-10036
–  Attach guide roller -V.A.G 1474/1- as shown in illustration.
–  Move reel -V.A.G 1654- to next position and continue cutting.
  A64-10037
–  Attach guide roller -V.A.G 1474/1- as shown in illustration.
–  Move reel -V.A.G 1654- to next position and continue cutting.
  A64-10038
–  Take out side window using double suction lifter -V.A.G 1344-.
  A64-10039

Preparations before installing a new window > < Exploded view - removing and installing side window