A4 Mk2
| Removing and installing belt guide (rear right and left) |
| 1 - | Belt guide (rear) |
| t | Removing: |
| – | Remove side padding → Chapter. |
| – | Remove C-pillar trim → Chapter. |
| – | Remove three-point seat belt (rear) → Chapter. |
| – | If fitted, take foam pad -4- out of bottom part of guide. |
| – | Working from underneath, slacken both cross-head bolts -2-. |
| – | Detach belt guide -1-. |
| t | Installing: |
| – | When installing belt guide -1-, make sure both washers -3- are beneath belt guide. |
| – | Press belt guide into fastener so that retaining tab -5- engages audibly. |
| – | Screw cross-head bolts -2- back in again. |
| – | Re-insert foam pad -4- into belt guide -1-. |
| – | Re-install all other components removed earlier. |
| 2 - | Cross-head bolts (2x) |
| 3 - | Washers (2x) |
| 4 - | Foam section |
| q | Depending on equipment version |
| 5 - | Retaining tab |
