A4 Mk2
|
|
WARNING
|
1 - | Crash sensor for side airbag (front) |
t | Removing: |
Note
Illustration shows front crash sensor for side airbag on passenger's side. Removal and installation on driver's side are performed in the same manner. |
– | Disconnect battery earth strap → Electrical system; Rep. gr.27. |
– | Remove B-pillar trim (bottom) → Chapter. |
– | Unfasten seat belt; complete removal is not necessary → Chapter. |
– | Take out foam section of B-pillar trim (bottom). |
– | Loosen the two bolts -2- at crash sensor from outside. |
– | Release tab at yellow connector -3- and unplug connector. |
t | Installing: |
– | Switch on ignition. |
WARNING
|
– | Connect battery earth strap → Electrical system; Rep. gr.27. |
Note
t | Observe measures to be taken after connecting the battery → Electrical system; Rep. gr.27. |
t | If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester. |
2 - | Bolts (2x) |
q | Tightening torque: 9 Nm |
3 - | Connector |
4 - | B-pillar |