A4 Mk2
|
|
|
|
|
| 1 - | Four-way lumbar support motors (2x) |
| 2 - | Seat height adjustment motor |
| 3 - | Seat rake adjustment motor |
| 4 - | Seat longitudinal adjustment motor |
| 5 - | Backrest adjustment motor |
| t | Removing |
| – | Remove seat → Chapter. |
| – | Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
| – | Attach front seat to seat repair stand -VAS 6136-. |
| – | Remove side trim (sill side) → Chapter. |
| – | Remove side trim (tunnel side) → Chapter. |
| – | Remove backrest cover panel → Chapter. |
Note| The illustration shows the backrest of the front passenger's seat. |
| – | Slacken off bolt securing backrest adjustment motor → Fig.. |
| – | Use screwdriver to prise off spring washer -5- on side of backrest motor (detail view -B-). |
| – | Using a hammer and punch, knock shaft -4- through side of backrest frame. |
| – | Pull shaft -4- out of backrest frame -1- until backrest adjustment motor is released and you can take it out. |
| t | Installing |
| – | Align splines of new backrest adjustment motor → Fig.. |
| – | Push shaft -4- through backrest adjustment motor and through backrest frame -1-. |
| – | Move seat aside. |
| – | On opposite side of backrest adjustment motor, place wooden block -2- beneath shaft -4- (detail view -A-). |
| – | Use 11 mm socket attachment -3- to knock spring lock washer -5- onto shaft -4- (detail view -C-). |
| – | Tighten bolt on backrest adjustment motor and plug in connector. |
| Perform remaining installation in reverse order of removal. |
| – | Seats with seat memory: After installing seat in vehicle, perform basic setting of backrest/seat. |
| 1 - | Backrest frame |
| 2 - | Wooden block |
| 3 - | Socket (11 mm) |
| 4 - | Shaft |
| 5 - | Spring washer |
|
|
|
|
