A4 Mk2
Removing and installing 1/3 section of backrest (left-side) |
t | Removing: |
– | Fold both backrests forwards. |
– | Unclip trim -3- from rear in direction of arrow. Prise out through hole from rear if necessary. |
– | Unscrew bolt -1- and remove clamp -2-. |
Tightening torque for bolt -1-: 10 Nm |
– | Lift backrest -1- out of centre bracket -2- in direction of arrow -A- and pull off fitting -3- in direction of arrow -B-. |
Note
Re-fit grommet -4- if it is pulled out of outer fitting when removing backrest. |
t | Installing: |
Install in reverse order of removal. |
1 - | Bolt |
2 - | Clamp |
3 - | Cover |
1 - | Backrest |
2 - | Centre bracket |
3 - | Fitting |
4 - | Grommet |